Mercedes-Benz SLS AMG 2012 Operator's Manual page 209

G
WARNING
If the indicator lamp in the SOS button is
flashing continuously and there was no voice
connection to the Response Center
established, then the mbrace system could
not initiate an emergency call (e.g. the
relevant cellular phone network is not
available).
The message Call Failed
multifunction display for approximately
10 seconds.
Should this occur, assistance must be
summoned by other means.
Making an emergency call
To initiate an emergency call
X
manually: press cover : briefly to open
it.
Press SOS button ; briefly.
X
The indicator lamp in SOS button ;
flashes until the emergency call is
concluded.
Wait for a voice connection to the
X
Mercedes-Benz Customer Assistance
Center.
After the emergency call is ended, close
X
cover :.
G
WARNING
If you feel at any way in jeopardy when in the
vehicle (e.g. smoke or fire in the vehicle,
vehicle in a dangerous road location), please
do not wait for voice contact after you have
pressed the SOS button. Carefully leave the
vehicle and move to a safe location. The
Response Center will automatically contact
local emergency officials with the vehicle's
approximate location if they receive an
automatic SOS signal and cannot make voice
contact with the vehicle occupants.
Roadside Assistance button
appears in the
Press and hold Roadside Assistance
X
button : for more than two seconds.
This initiates a call to the Mercedes-Benz
Customer Assistance Center. The indicator
lamp in Roadside Assistance button :
flashes while the call is active. The
Connecting Call
multifunction display. The audio output is
muted.
If a connection can be made, the
Connected
multifunction display.
If a cellular phone network is available and
there is sufficient GPS reception, the mbrace
system transmits data to the Mercedes-Benz
Customer Assistance Center, for example:
current location of the vehicle
R
vehicle identification number
R
i
The COMAND display shows that an
mbrace call is active. During the call, you
can change to the navigation menu by
pressing the NAVI button on COMAND, for
example.
Voice output is not available.
Features
message appears in the
Call
message appears in the
207
Z