Table of Contents
Advertisement
MWB
Shooting Mode Selector
No indication
(Auto)
MWB
White balance mode indicator
NOTES:
To switch to automatic white balance adjustment, press MWB until the indication disappears, or turn the
Shooting Mode selector to "FULL AUTO".
Re-adjust the White Balance mode when the lighting has changed, when the camcorder has been turned on and
off again, or when the Shooting Mode selector's position has been changed.
It is helpful to connect your camcorder to a color monitor when adjusting the white balance
("Basic Connections"
pg. 37).
When adjusted by putting colored paper in front of the subject in step 2 ("ADJUST FOCUS"), this unit makes its
color temperature standard for automatic white balance. So you can enjoy shooting with different colors. For
example, when adjusting with red, blue or yellow colors, the image becomes the color which aproximates to
green, orange or purple respectively.
White Balance Adjustment
This camcorder's Automatic Color Temperature system
senses the color temperature of the ambient lighting for
automatic white balance adjustment. However, precise
color adjustment is not possible under the following
conditions:
•When an object is in various shades of the same color.
•When a predominantly red or brown object is being
shot outdoors.
In these cases, use the camcorder's built-in preset filters
for white balance adjustment.
SELECT SHOOTING MODE
1
Set the Shooting Mode selector to "PRESET".
SELECT FUNCTION
2
Press MWB (Manual White Balance) until the
required indication appears in the viewfinder.
"MWB" .... With a memorized personal White
................
"
" ......... Outdoors on sunny day
"
" ........Outdoors on cloudy day
" " ..........Light source is halogen or tungsten lamp
MWB sets the color temperature for the subject's light
source so you can shoot with natural colors that are
MWB
unaffected by surroundings, even when there are
multiple subjects with different color temperatures.
SELECT SHOOTING MODE
1
Set the Shooting Mode selector to "PRESET".
ADJUST FOCUS
2
Point the camcorder at a white, flat object such as a
sheet of white paper, and adjust focus manually
(
pg. 25).
ADJUST WHITE BALANCE
3
Press MWB until "MWB" appears, then press and
hold MWB for more than 3 seconds.
•"MWB" blinks in the viewfinder during
adjustment, then stops blinking but stays lit when
adjustment is complete.
Balance setting (see below)
23
Advertisement
Table of Contents
