White Balance Adjustment - JVC GR-AX760 Instructions Manual

Shooting Mode Selector
No indication
(Auto)
NOTES:
● To switch to automatic white balance adjustment, press MWB until the indication disappears, or turn the
● Re-adjust the White Balance mode when the lighting has changed, when the camcorder has been turned on and
● It is helpful to connect your camcorder to a colour monitor when adjusting the white balance
● When adjusted by putting coloured paper in front of the subject in step 2 ("ADJUST FOCUS"), this unit makes its
Downloaded from: https://www.usersmanualguide.com/
MWB
MWB
White balance mode indicator
Shooting Mode selector to "FULL AUTO".
off again, or when the Shooting Mode selector's position has been changed.
("Basic Connections" pg. 33).
colour temperature standard for automatic white balance. So you can enjoy shooting with different colours. For
example, when adjusting with red, blue or yellow colours, the image becomes the colour which aproximates to
green, orange or purple respectively.

White Balance Adjustment

This camcorder's Automatic Colour Temperature system
senses the colour temperature of the ambient lighting for
automatic white balance adjustment. However, precise
colour adjustment is not possible under the following
conditions:
•When an object is in various shades of the same colour.
•When a predominantly red or brown object is being
shot outdoors.
In these cases, use the camcorder's built-in preset filters
for white balance adjustment.
SELECT SHOOTING MODE
1
Set the Shooting Mode selector to "PRESET".
SELECT FUNCTION
2
Press MWB (Manual White Balance) until the
required indication appears in the viewfinder.
"MWB" .... With a memorized personal White
................ Balance setting (see below)
" " ......... Outdoors on sunny day
" " ........Outdoors on cloudy day
" " ..........Light source is halogen or tungsten lamp
MWB sets the colour temperature for the subject's light
source so you can shoot with natural colours that are
MWB
unaffected by surroundings, even when there are
multiple subjects with different colour temperatures.
SELECT SHOOTING MODE
1
Set the Shooting Mode selector to "PRESET".
ADJUST FOCUS
2
Point the camcorder at a white, flat object such as a
sheet of white paper, and adjust focus manually
( pg. 21).
ADJUST WHITE BALANCE
3
Press MWB until "MWB" appears, then press and
hold MWB for more than 3 seconds.
•"MWB" blinks in the viewfinder during
adjustment, then stops blinking but stays lit when
adjustment is complete.
19
EN