Advertisement
assembly
Warning
charger specified for the battery.
For specific charging instructions, read the
operator's manual supplied with your charger
and battery.
Inserting/Removing the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
To insert the battery, slide the pack into the body of
the tool. Make sure it latches securely into place.
Warning
pack before changing or removing
accessories. Only use accessories specifi-
cally recommended for this tool. Others may
be hazardous.
Warning
Use only sockets and other
accessories specifically designed
for use on impact wrenches and drivers.
Other sockets and accessories might shatter
or break causing injury.
Attaching and Removing Accessories
Square drive shank(Model No. M12 CIW38 &
M12 CIW12)
These impact wrenchs are intended only for use
with sockets designed for impact wrenches that
have a 3/8" or 1/2"(Model No. M12 CIW38 &
M12 CIW12)square drive. Other sockets could
shatter or break, causing injury.
1. To attach a socket or other accessory, align the
accessory with the drive shank and push it firmly
over the retaining ring.
2. To remove the accessory, pull the accessory off
the drive shank.
Hex drive chuck
(Model No. M12 CID)
This driver is intended for use with drill and driver
bits with a 1/4" hex shank and ball detent recess.
1. To attach an accessory, press the shank into the
hex drive chuck.
2. To remove the accessory, pull out the ring and
remove the accessory. Release the ring.
For technical review, sent 007 Feb 2014
Recharge only with the
Always remove battery
operaTion
Warning
pack before changing or removing
accessories. Only use accessories specifi-
cally recommended for this tool. Others may
be hazardous.
Warning
wear safety goggles or glasses with
side shields.
Fuel Gauge
To determine the amount of charge left in the bat-
tery, pull the trigger. The Fuel Gauge will light up
for 2-3 seconds.
To signal the end of charge, 1 light on the fuel
gauge will flash for 2-3 seconds.
Using the Drive Control
The drive control button is used to adjust the torque,
rotation speed (RPM), and impact speed (IPM) for
the application (see Specifications chart for RPM
and IPM).
To select the drive control mode:
1. Pull and release the trigger to
turn on the tool. The current
mode indicator is lit.
2. Press the drive control but-
ton
to cycle through the
2 modes. When the desired
mode indiator is lit, begin
work.
Using the Control Switch
The control switch may be set to three positions:
forward, reverse and lock. Due to a lockout mecha-
nism, the control switch can only be adjusted when
the ON/OFF switch is not pressed. Always allow
the motor to come to a complete stop before using
the control switch.
Push for
Forward
PUSH TO CENTER TO LOCK
1. For forward (clockwise) rotation, push the
control switch in the direction shown. Check the
direction of rotation before use.
2. For reverse (counterclockwise) rotation, push
the control switch in the direction shown. Check
the direction of rotation before use.
3. To lock the trigger, push the control switch to the
center position. The trigger will not work when
the control switch is in the locked position.
Always remove the battery pack before perform-
ing maintenance, changing accessories, storing
the tool and any time the tool is not in use.
5
Always remove battery
To reduce the risk of injury,
Drive Control
Mode
Indicator
Push for
Reverse
Button
Advertisement
