Abilize ranger Instruction Booklet page 11

Flash Description
l
Battery low or
1
low battery fault
High battery
2
Current limit
3
time-out
Park brake
4
Throttle
5
OONAPU
Speed pot
6
Motor voltage
7
Other error
8
Further issues:
If the above troubleshooting does not help to resolve
the issue please contact the authorised dealer (page 2).
Please have your serial no. to hand to provide to the
authorised dealer, which can be found on the battery pack.
•
•
fault
•
•
•
•
fluid
•
•
•
fault •
•
fault
•
Meaning
The batteries are running low.
Recharge the batteries for a minimum of 12 hours.
Battery voltage is too high. This may occur if
overcharged &/or travelling down a long slope.
If travelling down a slope, reduce your speed to
minimise the amount of regenerative charging.
Check the battery and associated connections and
wiring.
The motor has been exceeding its maximum
current rating for too long. This may be due to a
faulty motor.
Check the motor and associated connections and
wiring.
Turn the controller off, leave for a few minutes and
turn back on again.
Either a park brake release switch is active or
the park brake is faulty.
Check the park brake and associated connections
and wiring.
Ensure any associated switches are in their correct
positions.
The throttle is out of neutral when turning the
controller on.
Ensure the throttle is in neutral when turning the
controller on.
The throttle may require re-calibration.
The throttle, speed limit pot or their associated
wiring may be faulty.
Check the throttle and speed pot and associated
connections and wiring.
The motor or its associated wiring is faulty.
Check the motor and associated connections and
wiring.
The controller may have an internal fault.
Check all connections & wiring.
11