Table of Contents
Advertisement
Manual watering [ Fig. P5 ]:
The valve can be opened or closed manually at
any time. The controller must be fitted.
1. Turn the rotary knob to On.
The valve is opened, the drips flash one after the
other and the watering duration flashes (preset to
30 minutes at the factory) for 10 seconds in the
display.
2. Whilst the watering duration is flashing, it can
be modified with the + button (between 1 and
59 minutes) (example: 15 minutes) and confirmed
with the OK button.
3. Turn the rotary knob to Off to close the valve
early.
The valve is closed.
5. STORAGE
To put into storage / Overwintering:
1. To preserve the battery, it should be
removed (see 3. PUTTING YOUR WATER
COMPUTER INTO OPERATION).
When the battery is inserted again in spring, the
watering program must be newly entered again.
2. Store controller and valve unit in a dry place
where they are protected from frost.
24
The adjusted manual watering duration is saved
and is independent from the watering duration in
the program, i.e. the adjusted watering duration is
preset for each future manual valve opening.
Deactivate watering program [ Fig. P6 ]:
The watering program is not executed when the
knob is set to Off. The program remain stored.
A program-controlled open valve can also be closed
early without changing the program data (watering
start time, watering duration, watering cycle).
v Turn the rotary knob to Off.
The watering program is deactivated.
To reactivate the watering program turn the rotary
knob to Prog.
Disposal:
(in accordance with RL2012/19/EC)
The product must not be disposed of to
normal household waste. It must be dis-
posed of in line with local environmental
regulations.
Important! Dispose of the product through or via
your municipal recycling collection centre.
Advertisement
Table of Contents
