Assembling The Light Kit; Installing The Glass - Hunter Exeter Installation Manual

Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Partially install two of the light kit screws
found in the bag. It does not matter
which two screw holes you choose.
Install the included LED
bulbs into the sockets.
When necessary, replace
with bulbs of same wattage.
Ceiling Bracket Hanging Fan

Assembling the Light Kit

2 of 5
Light Kit Screw
bag
Note: Remove the pre-installed light kit
assembly screw and red flag from the light kit
assembly. Save the screw. It will be needed
for installation
2 of 5
Light Kit Screw
bag
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Align the keyhole slots in the light kit
housing with the two screws. Make sure
all the wires from the fan and the light kit
are snug inside the center of the light kit,
not pinched in between the upper switch
housing and the light kit or hanging out of
the sides.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Wiring
Feed the wire plug through the
center hole of the upper switch
housing, then wrap keyhole
slots around the screws and
twist counterclockwise.

Installing the Glass

Tab
Notch
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
Blades Light
bag
Insert the third screw,
found in the hardware
bag, into place and then
tighten all three screws.
bag
Turn the light kit counterclockwise until the
switch housing screws are firmly situated in
the narrow end of the keyhole slots. Install the
third screw and tighten all three screws
securely.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Remote Trouble Shooting
1886
1 of 5
Light Kit Screw
1 of 5
Light Kit Screw
8