Singer 14SH644 Operator's Manual page 16

• Turn the hand wheel toward you until the lower
looper is at the far right.
• Thread the looper area of the machine following
the yellow color coded thread guides 4 ~ 7 .
Note: Use the tweezers provided in the accessory
set to aid in threading the looper.
• Grasp the thread with the tweezers 4 cm (1-1/2
inches) from thread guide 7.
• Place the thread with the point of the tweezers
slightly under and to the left of threading guide 8.
• Pull the thread up and into thread guide 8.
• Pass the thread behind and over the top end of
left looper 9-A.
• Then pull it downward gently so that it will slip
into the slot in the looper 9-B.
• Pick up the thread and pass it through the hole in
the end of the looper 10 .
Note : Use the tweezers provided in the accessory
set to aid in threading the looper.
• The thread should be positioned in the groove of
the lower looper.
• Pull about 10cm (4 inches) of thread through the
looper and place it over the top of the upper
looper and to the back of the throat plate.
7
6
8
9 - B 9 - A
4
5
7
15