Do you have a question about the 14SH644 and is the answer not in the manual?
Questions and answers
Ray Bess
February 20, 2025
I still don't understand how to thread the machine
1 comments:
Mr. Anderson
February 20, 2025
To thread the Singer 14SH644 sewing machine, follow these steps:
1. Thread the Upper Looper: - Pass the thread through the thread guide. - Follow the red dots to thread through the guides and hooks. - Thread from front to back and pull about 10 cm (4 inches) of excess thread.
2. Thread the Lower Looper: - Pass the thread through the thread guide and latch it onto the back hook. - Guide it through the tension discs. - Turn the handwheel to make the lower looper visible. - Follow the yellow dots to thread through hooks and latches. - Use tweezers to latch the thread onto the back of the lower looper. - Pull a good amount of excess thread.
3. Thread the Upper Threads: - Start with thread three (green thread). - Pass it through the guide, hook, and tension discs. - Latch it into the two hooks positioned at the front of the machine.
Repeat similar steps for the remaining thread, following the color-coded threading guide.
Need help?
Do you have a question about the 14SH644 and is the answer not in the manual?
Questions and answers
I still don't understand how to thread the machine
To thread the Singer 14SH644 sewing machine, follow these steps:
1. Thread the Upper Looper:
- Pass the thread through the thread guide.
- Follow the red dots to thread through the guides and hooks.
- Thread from front to back and pull about 10 cm (4 inches) of excess thread.
2. Thread the Lower Looper:
- Pass the thread through the thread guide and latch it onto the back hook.
- Guide it through the tension discs.
- Turn the handwheel to make the lower looper visible.
- Follow the yellow dots to thread through hooks and latches.
- Use tweezers to latch the thread onto the back of the lower looper.
- Pull a good amount of excess thread.
3. Thread the Upper Threads:
- Start with thread three (green thread).
- Pass it through the guide, hook, and tension discs.
- Latch it into the two hooks positioned at the front of the machine.
Repeat similar steps for the remaining thread, following the color-coded threading guide.
This answer is automatically generated