Using The Showview Feature - Samsung DVD-R120 Instruction Manual

Using the ShowView
Feature
Before presetting your DVD Recoder:
• Switch on both the television and your DVD Recoder.
• Check that the date and time are correct.
Up to twelve programmes can be preset.
With the unit in Stop mode, press the
1
TIMER button. Press the ...† buttons to
select ShowView, then press the OK or √
button.
A message is displayed to allow you to enter the
G
ShowView code.
DVD-RAM(VR)
Disc Navigation
Playlist
Enter ShowView Code number. [0~9]
Disc manager
Programme
Setup
OK
Using the MENU button.
With the unit in Stop mode, press the MENU
G
button.
Press the ...† buttons to select Programme, then
G
press the OK or √ button twice.
Press the number buttons to enter the
2
code of the programme that you want to
record in your television magazine.
If you want to correct the ShowView code that
G
you are entering:
Press the œ button until the digit to be corrected
G
is cleared.
Enter the correct digit.
G
50
- English
RETURN EXIT
3 Press the OK button.
The information concerning the programme is
G
displayed.
When using the ShowView function for the
G
first time with stored stations, the programme
number flashes. This one time, you must enter
the PR number manually by pressing the
...† buttons or number buttons.
DVD-RAM(VR)
Recordable Time 02:12 SP
No. Source Date Start
No. 01
01 -- -- -- - -- --:-- --:--
Source Date Start
PR 01 01/JAN(SAT) 12 : 00 14 : 00 SP
Recordable Time 02:12 SP
MOVE OK
DVD-RAM(VR)
Recordable Time 02:12 SP
No. Source Date Start
01 PR 01 01 JAN 12 : 00 14 : 00 SP
02 -- -- -- - -- --:-- --:--
MOVE OK
4 If the programme and times are correct,
press the OK button.
Turn the power off by pressing the
5
STANDBY/ON button to activate the timer
recoding setting.
6 Refer to pages 47~49 if you want to:
Check whether the timer Recording has set
G
correctly or not.
Cancel a preset recording
G
The numbers next to each TV programme
I
listing in the magazines or newspapers
NOTE
are ShowView code numbers, which allow
you to programme your DVD Recorder
instantly with the remote control. Enter
the ShowView code for the programme
you wish to record.
ShowView is a trademark of Gemstar
I
Development Corporation. The ShowView
system is manufactured under licence
from Gemstar Development Corporation.
Scheduled Record List
End Mode V/P Edit
-- --
√ √
End Mode V/S
Off
RETURN EXIT
Scheduled Record List
End Mode V/P Edit
Off
√ √
-- --
√ √
RETURN EXIT