Husqvarna ST 224 P Operator's Manual page 6

ASSEMBLY / PRE-OPERATION
INSTALL DISCHARGE CHUTE / CHUTE ROTATOR
HEAD (See Fig. 4 and 5)
NOTE: The multi-wrench provided in your parts bag may
be used to install the chute rotator head.
1. Place discharge chute assembly on top of chute base
with discharge opening toward front of snow thrower.
2. Position chute rotator head over chute bracket. If nec es-
sary, rotate chute assembly to align square and pin on un-
der side of chute rotator head with holes in chute brack et.
3. With chute rotator head and chute bracket aligned,
po si tion chute rotator head on pin and threaded stud
of mounting bracket.
4. Install locknut and cable guide on threaded stud and
tighten securely.
LOCKNUT
CHUTE
ROTATOR
HEAD
ALIGN BEFORE
CHUTE
TIGHTENING LOCKNUT
BRACKET
5. Place rotator cables through cable guide and secure
cables to the lower handle using the double clip.
DOUBLE
CLIP
ROTATOR
CABLES
CABLE GUIDE
PIN
THREADED
STUD
ROTATOR HEAD
MOUNT ING
BRACKET
FIG. 4
ROTATOR
CABLES
CABLE GUIDE
FIG. 5
INSTALL CHUTE DEFLECTOR REMOTE CONTROL
(See Figs. 6 and 7)
1. Install remote cable bracket to discharge chute with
5/16-18 carriage bolt and 5/16-18 locknut as shown.
Tighten securely.
2. Install remote cable eyelet to chute deflector with
1/4-20 shoulder bolt, nylon washer and 1/4-20 locknut
as shown. Tighten nut securely. Eyelet will be loose
on shoulder bolt.
3. Install spring hooks between hex nuts on chute rotator
head and into hole in chute deflector as shown.
1/4-20
SHOULDER
BOLT
NYLON
WASHER
1/4-20
LOCK NUT
CABLE
EYELET
REMOTE
CABLE
BRACKET
5/16-18
LOCKNUT
4. Install all control lever knobs by pressing them down
onto the control levers.
KNOB
CHECK TIRE PRESSURE
The tires on your snow thrower were overinflated at the fac-
tory for shipping purposes. Correct and equal tire pres sure
is important for best snow throwing performance.
• Reduce tire pressure to 14-17 PSI.
6
SPRING
DE FLEC TOR
HOOK
BE TWEEN
HEX NUTS
ON CHUTE
ROTATOR
HEAD
CARRIAGE
FIG. 6
KNOB
CONTROL LEVER
FIG. 7
CHUTE
5/16-18
BOLT