Mounting The Expansion Module And Phone On A Wall; Adjusting The Tilt Base - Nortel 1100 Series User Manual

Mounting the expansion module and phone on a wall

You can wall-mount an IP Phone with an expansion module. You need the mounting template and
the mounting bracket that came with the expansion module. You must attach the expansion
module to your IP Phone before you mount them on the wall.
Complete this procedure if you plan to mount the base station on a wall or ceiling. Skip this
procedure if you plan to place the base station on a flat surface.
1 Place the mounting template against the wall where you want to install the IP Phone and
expansion module.
The template provides guidelines for mounting one IP Phone with up to two or more
expansion modules.
2
Use the mounting template to position the IP Phone and expansion module.
3 Mark the screw positions.
4 Use the screws to attach the mounting brackets to a wall.
5
Align the notches on the back of the IP Phone and expansion module with the mounting
bracket on the wall.
6 Push the IP Phone and expansion module against the brackets until they are securely
connected.

Adjusting the tilt base

The expansion module stand provides a continuous tilt adjustment so the tilt angle matches the IP
Phone stand angle while accommodating variations in the desk surface. Use the clamp mechanism
to unlock and lock the foot stand angle.
Caution: Risk of damaging equipment
Do not over-tighten the foot stand wheel on the expansion module. This can
damage the wheel and the stand.
1 Turn the wheel on the back right-hand side of the expansion module to loosen the foot stand
hinge.
2 Adjust the angle of the IP Phone using the tilt lever.
3 When the IP Phone is set to a preferred angle, turn the wheel on the back of the expansion
module to tighten the foot stand hinge and lock the stand at the same angle as the attached IP
Phone.
Chapter 3 Installing the expansion module
Expansion Module 1100 Series User Guide
23