Before using for the first time
Settings for compartment
The UltraPhase 2 values are preset in
the standard settings.
After the cartridge has been pushed in,
the display message switches to:
Agent for
Confirm with the OK sensor control.
Miele UltraPhase 2
Confirm with the OK sensor control.
The dispensing quantity for
UltraPhase 2 is preset for (hardness
level II).
Per load
Confirm the preset value with the
OK sensor control. If you want to
change this value, use the
sensor controls and confirm with
the OK sensor control.
UltraPhase 2
Hardness level I
Hardness level II
Hardness level III
The following will appear in the display:
Insert
22
OK
OK
45
ml
OK
36 ml
45 ml
54 ml
Remove the film from the detergent
cartridge.
Push the UltraPhase 2 detergent
cartridge into compartment 2 until it
locks into position.
When the cartridge is pushed in, the
display message switches to:
"TwinDos" is set. Can be changed in "Set-
tings".
Confirm with the OK sensor.
Close the TwinDos access panel.