Advertisement
1
If required, the alignment of the coffee maker can be adjusted by placing the
supplied spacers either under or to the sides of the rails.
To adjust the height of the coffee maker front by ±2mm, rotate the lever
2
located where the coffee maker and rails meet.
Fix the power cable with the clip. The power cable must be long enough to allow
4
the appliance to be extracted from the cabinet to fill the coffee bean container.
The appliance must be earthed in compliance with legislation.
●
Electrical connections must be performed by a qualified electrician following
●
the instructions.
8
INSTALLATION INSTRUCTIONS
approx. 13 3/4" (350mm)
3
Align the rails to the sides of the cabinet before securing using the provided screws.
Extending both rails fully.
If the coffee maker is installed over a warmer drawer, use the top surface of this as
●
a reference to position the rails.
In this case, there will be no surface to rest the rails on.
●
Position the appliance on the rails, making sure the pins are correctly inserted
5
in the housings, then fix it with the screws supplied. If the height of the appliance
requires adjusting, use the spacer disks provided.
Advertisement
