IBM Aptiva 2174 Hardware Maintenance Service page 127

Installing the Processor Fan Sink
The AMD K-7 processor module has holes on one side to hold the clips of the
fan sink. The upper set of holes (near the latches) on the processor are wider
and should match the wider ends of the clips on the fan sink. The lower set of
holes are smaller and should match the narrow ends of the fan sink clips.
Package Installation
Follow these steps when installing the fan sink to the AMD K-7 processor
module:
•
Remove the thermal tape protector at the back of the fan sink.
•
Attach the fan sink to the PC board side of the AMD K-7 processor.
•
Press the fastener towards the fan sink side to lock the fan sink.
.
Repair Information 95