Adding Transmitters; Entering Programming - Pyle PWD203 User Manual

easily accessible from the driver's seat.
4-Pin White Connector A: Plug-in connector
port for dual stage shock sensor.
4-Pin White Connector B: Plug-in connector
port for optional dual stage radar sensor.

Adding Transmitters

To add a new transmitter to the system have the
desired transmitters ready and follow the Code
Learning sequence.
To enter Code Learning Mode:
1. Turn the ignition on, off, on, off and leave on.
• The siren will chirp once.
2. Press and hold the Valet switch for 5
seconds.
• The siren will chirp 3 times.
3. Press the Lock Button on the transmitter.
• The siren will chirp once.
4. Press Lock Button on the transmitter again.
• The siren will chirp twice.
5. Repeat steps 3 and 4 for each additional
transmitter (up to 4 total).
6. Turn off the ignition.
• The siren will chirp 3 times.
Two Car Operation
With the supplied 5-button transmitter it is
possible to control a second vehicle using the
same primary transmitter. For Car 2 enter the
Code Learning Mode as described above then
substitute the steps below for 3 and 4 above.
3. Press Button 5 twice followed by the Lock
Button.
• The siren will chirp once.
4. Press Button 5 twice followed by the Lock
Button again.
• The siren will chirp twice.

Entering Programming

To enter System Programming:
1. Turn on ignition.
2. Within 5 seconds, press valet switch 5
times.
• The siren will emit a long chirp, to
indicate entering program mode.
3. Press the valet switch the number times
equal to the desired feature.
• The siren will chirp each time the valet
switch is pressed. A long chirp is equal to
5 presses. (Example: step 7 = 1 long chirp
and 2 short chirps.)
4. Within 5 seconds, press the transmitter
button corresponding to the desired
operating mode for that feature.
• The siren will chirp to indicate the
setting.
One chirp = Button 1
Two chirps = Button 2
Three chirps = Button 3
Four chirps = Button 4
5. Repeat steps 3 and 4 to change additional
features.
6. Turn off ignition to save changes.
Complete Default Reset
This procedure will set all Programmable
Features to factory default settings.
1. Enter System Programming.
2. Press Transmitter Button 3.
• The siren will chirp 6 times indicating the
reset signal was received.
• All Installer and User Programming options
are now set to factory default settings.
3. Turn ignition off.
7