Installation Instructions - Pyle PWD203 User Manual

INSTALLATION INSTRUCTIONS

Before you begin the installation
• Read the INSTRUCTIONS!
• Always use a multi-meter when verifying
vehicle wiring.
• Before mounting the product, verify with the
customer the desired location for the valet
switch and LED.
• Protect the vehicle by using fender covers.
• Always look before drilling. Make sure you
will not cause damage to vehicle hoses,
electrical looms or physical damage to vehicle.
• Set the Polarity Jumpers inside the main unit.
(see Jumper Settings)
Mounting System Module
Mount the system module under the dash
where it will be difficult for a potential thief to
locate the module, and away from moving parts
such as brake pedals, etc. Route the antenna
wire away from wire looms, computer modules
and metallic objects for better range.
Mounting Siren
Mount the siren in a suitable place under the
hood, away from hot and moving engine parts
such as manifolds, fan belts, etc. Make sure the
siren cannot be accessed from underneath the
vehicle or through the grill. Face the siren down
so that water cannot accumulate inside the
siren bell. Protect wires running through the
firewall using either tape or split loom tubing. If
a new hole is needed, protect the wire from
chaffing by installing a proper size grommet.
Mounting Shock Sensor
Secure the shock sensor to the steering
column, thick wire harness or a dash brace,
using a wire tie. Make sure that the adjustment
screw is accessible for later testing and
adjustment.
16-Pin Main Harness:
• BROWN WIRE - Siren wire output (+) 3A.
Connect to the siren's red wire. Connect the
siren's black wire to ground.
• BLACK WIRE - Ground input (-). Connect to
a solid chassis ground that is clean and free of
paint or dirt.
• ORANGE WIRE - Armed Output (-) 500mA.
Connect to a relay for optional circuit defeat
(See installation diagrams). The ORANGE wire
provides a ground when the unit is armed to
activate a fuel pump disable relay or other
device (i.e. window control module, etc.).
• EMPTY - not used.
• YELLOW WIRE - +12V Ignition input.
Connect to a main ignition wire at the ignition
switch harness.This wire shows +12V when the
ignition is on and while cranking. The voltage
must not drop when the car is starting.
• BROWN/WHITE WIRE - Horn output (-)
500mA. Connect to an optional relay to honk
the vehicle's horn when the alarm is triggered.
• BLACK/YELLOW WIRE - Auxiliary 3 output
(-) 500mA. Connect to a relay for an optional
feature such as headlight activation, etc. This
output may be programmed for momentary,
timed, or latched operation.
5