Adding Transmitters - Pyle PWD202 User Manual

Test System and Adjust Shock Sensor
Arm and disarm system, checking that the siren
chirps and parking lights are functioning
normally. Make sure that the programmed
features are performing correctly, ie.: ignition
locks, passive arming, passive locks, etc.
Test the doors and hood/trunk inputs (make
sure all doors trigger the system, not just the
driver's door).
Adjust the shock sensor.
Arm the system and try starting the vehicle, it
should not start.
Arm the system and disarm it using the
emergency overide feature.
If programmed to passively arm make sure that
the system arms properly.
Check the range of the remote transmitters.
Tie up wire harness, and replace any under dash
panels.
Make sure the customer has physical knowledge
of the location of the valet/override switch.

Adding Transmitters

To add a new transmitter to the system have the
desired transmitters ready and follow the Code
Learning sequence.
To enter Code Learning Mode:
1. Turn the ignition on, off, on, off and leave on.
• The siren will chirp once.
2. Press and hold the Valet switch for 5
seconds.
• The siren will chirp 3 times.
3. Press the Lock Button on the transmitter.
• The siren will chirp once.
4. Repeat step 3 for each additional transmitter,
up to four total transmitters.
5. Turn off the ignition.
• The siren will chirp 3 times.
NOTE: If a transmitter is lost of stolen, make sure
to code all 3 transmitter memory locations.
(Example: If only one transmitter is used, repeat
step 3 two more times to remove any previously
programmed transmitters.)
7