Table of Contents
Advertisement
PASSIVE ARMING
The passive arming feature allows the system to
automatically arm after closing all doors. The
Passive Arming feature requires the ignition to
have been on for at least 10 seconds prior to
exiting the vehicle. This enables the key to be
turned on then off quickly to avoid passive
arming in the event of refueling, washing the
vehicle, etc. The Passive Arming feature may be
enabled during installation.
To arm the system passively:
1. Turn the ignition key off (make sure
ignition was on for at least 10 seconds).
2. Exit the vehicle and close all doors.
• The LED flashes rapidly indicating that
the system is preparing to arm. (The
system can be armed at any time by
pressing transmitter button 1.)
• If the optional countdown feature is
programmed, the siren will chirp every
2 seconds until armed.
• The siren will chirp 30 seconds after
the last door is closed to indicate the
system is armed. NOTE: Opening the
hood/trunk or a door resets the passive
arming timer.
• The doors will lock.†*
†
If Passive Locking was enabled during installation.
DISARMING OPERATION
To disarm the system press transmitter button 2.
• The siren will chirp twice.
• The parking lights will flash twice.*
• The doors will unlock.†*
• The dome light will turn on for 30
seconds.*
†
If the Passenger Unlock Feature is installed, pressing
the unlock button will unlock only the driver's door.
Pressing the unlock button again unlocks all doors.
TAMPER ALERT
If the alarm was triggered while away from the
vehicle, the siren will chirp 3 times and the
parking lights will flash 3 times on disarming for
tamper indication. After disarming the alarm,
enter vehicle and turn ignition on.The LED will
flash the zone that was triggered 3 times (see
LED TAMPER ALERT INDICATIONS).
AUTO REARM
The Auto Rearm feature allows the system to
automatically re-arm itself and lock the doors*
in the event the system is disarmed and a
door is not opened within 30 seconds. This
programmable feature may be enabled during
installation.
SILENT ARMING/DISARMING
Press transmitter button 5 (the Shift Button)
then the Arm or Disarm button for one-time
silent operation.The system can also be
programmed for full-time silent operation
during installation.
IGNITION LOCK*
The ignition locking feature automatically locks
the doors 5 seconds after the ignition key is
turned on, and automatically unlocks when the
ignition key is turned off. To avoid locking keys
in the vehicle, the ignition locking feature will be
cancelled if a door is open when the ignition is
turned on. This feature may be disabled during
installation.
*
Optional feature
REMOTE PANIC
In the event of an emergency (PANIC) situation,
the system's siren can be triggered for 30
seconds to attract attention.To activate the Panic
Feature, press transmitter button 1 for 3
seconds:
2
Advertisement
Table of Contents
