Advertisement
This guide is for quick reference only
To view the full manual, please scan this QR code using your smarphone or visit the product page at www.dimplex.co.uk
This product complies with Lot20 of the Energy Efficiency Directive (2015/1188)
Model Identifier(s):
Heat Output
Nominal heat output
Minimum heat output (indicative)
Maximum heat output
Auxiliary electricity consumption
At nominal heat output
At minimum heat output
In standby mode
Type of heat output / room temperature control
Type of heat output / room temperature control
Electronic heat charge control with room and / or outdoor
temperature feedback
Other control options
Room temperature control, with open window detection
With adaptive start control
The heater is designed for wall mounting using the wall bracket supplied. It should only be operated when in the upright position as shown
- see Fig. 1. All models are splash proof to IP24. Before connecting the heater check that the supply voltage is the same as that stated on
the heater.
IMPORTANT The wall bracket supplied with the heater must be used and the heater must be installed in the correct orientation. The
fixings should be used to secure the bracket to the particular wall on which the heater will be installed. The heater should be positioned
observing the minimum clearances stated around the heater - see Fig. 1.
A
To mount the heater to the wall:
1. Remove wall mounting plate from the back of the heater by removing the M4x20 screw with a Pozi Head No.2 screwdriver
see Fig 3
2. Fix the wall bracket securely to the wall through the four screw holes provided referring to dimensions in Fig. 1, Fig. 2.
3. Present the heater to the wall bracket and engage bottom slots in the back with bracket hooks.
4. Position the top slots onto the top hooks and slide the heater downwards until the slots come to a positive stop.
5. Re-insert the M4x20 screw in the M4 clinch nut on the wall bracket. This secures the heater to the wall plate.
WARNING:
This product is heavy and care should be taken in installation
Energy Related Product Directive
Pnom
Pmin
Pmax,c
elmax
elmin
elSB
General Information
Wall Mounting
Fig. 2
B
C
LST050E
LST075E
0.50kW
0.75kW
N.A
N.A
0.50kW
0.75kW
0.00
0.00
0.00
0.00
<0.0005
<0.0005
LST100E
LST150E
1.00kW
1.50kW
N.A
1.00kW
1.50kW
0.00
0.00
<0.0005
<0.0005
Yes
Yes
Yes
N.A
0.00
0.00
Fig. 3
Advertisement
