McCulloch M125-85FH Operator's Manual page 18

To clean the cold air intake of the
engine
WARNING: Stop the engine. The cold air
intake rotates and can cause injury to your
fingers.
1. Make sure that the intake grille on the engine cover
is not blocked. Remove grass and dirt with a brush.
2. Open the engine cover.
3. Make sure that the cold air intake is not blocked.
Remove grass and dirt with a brush.
To remove the covers
To remove the engine cover
1. Fold the seat forward.
18
2. Remove the screw below the seat.
3. Push the engine cover rearward.
To remove the front cover
1. Release the front cover clip on the right side of the
cutting deck. Use the tool attached to the ignition
key.
2. Remove the front cover.
To remove and attach the servicing hatch
1. Put a screwdriver at the front edge of the servicing
hatch (A).
2. Push down the screwdriver to remove the servicing
hatch (B).
A
B
3. To attach the servicing hatch, bend the ends (B) of
the servicing hatch and put the ends into the
opening.
623 - 001 - 06.03.2018