Golden Technologies Buzzaround Lite GB121 Owner's Manual page 35

4 Beeps
• Indicates that the motor control board is overloaded and overheated.
• An overload can occur if you have been driving your Buzzaround Lite for an extended
period of time up an incline above the recommended 6 degrees.
• An overload can occur if your Buzzaround Lite is carrying a payload that is higher than
the recommended weight capacity of 300 pounds.
• Your scooter will not operate until the motor control board cools back to its operational
temperature range.
Remedy:
• Turn off your Buzzaround Lite's key switch and allow the scooter to sit for 10 minutes.
• Consult your authorized Golden Technologies, Inc. provider.
5 Beeps
• Indicates a brake problem.
• The freewheel lever may be in the disengaged position. See page 19.
• The brake or the brake wiring may be damaged.
• For safety reasons, your scooter was designed to cease operation until the problem is
corrected.
Remedy:
• Make certain that the freewheel lever is in the engaged position. See page 19.
• Turn the key switch to the "Off" position to stop the beep code.
• Set the freewheel lever to the "engaged" position.
• Turn the key back to the "On" position.
• If the above remedies do not solve the problem, contact your authorized Golden
Technologies, Inc. provider.
6 Beeps
• Indicates that the throttle control lever was not in the neutral position when the key
switch was turned to the "On" position.
• May indicate that the throttle control lever is out of adjustment.
Remedy:
• Turn the key switch to the "Off position.
• Make certain that the throttle control lever is in the neutral position.
• Turn the key switch to the "On" position.
If the above procedure does not solve the problem, contact your authorized Golden

Technologies, Inc. provider.
7 Beeps
• Indicates a problem with the throttle control lever.
• May also indicate a problem with the potentiometer (speed control.)
• Your scooter will not operate until the problem is resolved.
Remedy:
• Make certain that all electrical connections are firmly and correctly joined.
• If the connections are all firmly joined and the problem is not solved, contact your
authorized Golden Technologies, Inc. provider.
X. CARE AND MAINTENANCE
35