Kenmore Elite 51403 Series Use & Care / Installation Manual page 12

7. Install the proper installation brackets according to
the type of cabinet (framed or frameless). See below.
FRAMED CABINET
Refer to the marking on the brackets to determine
the correct installation side and orientation.

Mate the corresponding bracket to the cabinet
side frame, while placing rear end of bracket
against the wall. Use a pencil to mark 3 holes
(there are 6 holes but only 3 are necessary).

Remove the bracket. Using a 7/64" drill bit,
drill 3 holes where marked.

Assemble the bracket to the side frame using a
Phillips screwdriver and 3 provided no. 8 x 5/8"
wood screws. Repeat for the other side frame.
FRAMELESS CABINET
Refer to the marking on the brackets to determine
the correct installation side and orientation.

Align the corresponding bracket to the cabinet
side, while placing rear end of bracket against
the wall. Draw a line on the outer edge of the
bracket (as shown).

Slide the bracket towards the center of cabinet
and align the outside edge of the bracket with the
marked line, keeping the rear end edge leaning
on the wall.

Use a pencil to mark 3 holes.

Remove the bracket. Using a 7/64" drill bit,
drill 3 holes where marked.

Assemble the bracket to the cabinet bottom using
a Phillips screwdriver and 3 provided countersunk
wood screws. Repeat for the other cabinet side
3 X
7/64"
.
12
7/64"