Pyle PLVW65M Owner's Manual page 10

INSTALLATION
1. Press the switch under the headrest of the car seat and pull out the headrest.
Headrest
2. Combine the base B (2) and the base A with steel ripple pipe (1), then place them
on the poles of the removed headrest to select proper hole position to install the
base.
Steel ripple pipe
3. Remove the base from the handrest and loosen the two screws by using the
screwdriver, then place the two plastic tubes (3) on the holes that you just
selected, then adjust them to proper position as shown in diagram below.
(3) Plastic tube
Switch
(1)
10
(2)