Installation And Operator Instructions - Lincoln Electric COOL ARC 60 Operator's Manual

Installation and Operator Instructions

Read this entire section before installation or operation of
the machine.
WARNING
ELECTRIC SHOCK can kill.

Do not operate with covers removed.

Do not operate if cables are wet or
immersed in water.
MOVING PARTS can injure.

Moving parts can injure. Never place
fingers into openings of Cooler.
HOT COOLANT can burn skin.

Always be sure coolant is NOT HOT
before servicing the cooler.
LOCATION
This machine will operate in harsh environments.
However, it is important that simple preventative
measures are followed to assure long life and reliable
operation.

Do not place or operate this machine on a surface with
an incline greater than 15° from horizontal.

Do not use this machine for pipe thawing.

This machine must be located where there is free
circulation of clean air without restrictions for air
movement to and from the air vents. Do not cover the
machine with paper, cloth or rags when switched on.

Dirt and dust that can be drawn into the machine
should be kept to a minimum.
This machine has a protection rating of IP23. Keep it
dry when possible and do not place it on wet ground
or in puddles.

Locate the machine away from radio controlled
machinery. Normal operation may adversely affect the
operation of nearby radio controlled machinery, which
may result in injury or equipment damage. Read the
section on electromagnetic compatibility in this
manual.

Do not operate in areas with an ambient temperature
higher than 40°C. The ambient air temperature
influences the parameters of cooling. If the ambient
temperature is higher, the cooling system will be less
effective.
WARNING
Avoid placing the cooler near areas of extreme heat.
RECOMMENDED POWER SOURCE
The COOL ARC ® 60 is designed for use with water-
cooled torches. The COOL ARC
the welding power sources that lists the COOL ARC
as an approved accessory.
English
® 60 must be used with
®
60
Input Supply Connection
The COOL ARC ® 60 is supplied by a welding power
source in accordance with installation procedure that can
be done only by qualified electrician. Installation must be
made in accordance with the appropriate National
Electrical Code and local regulations.
Do not run cooler if the reservoir was not filled and the
torch's/gun's hoses are disconnected from the cooling
unit. Not observing this warning may cause internal
damage to the cooler unit.
Controls and Operational Features
1
4 5
7
WARNING
2
3
4
6
Figure 7
5
English