Example 2:Set Sound Mix Output Mode; Example 3:Coaxial Output - Pyle PLDVD120 Operating Instructions Manual

System setting
2.Push [RIGHT] to enter the sub-menu in the sub-menu in the
right screen. If you want to set the screen to "WIDE", firstly push
[DOWN] twice to move the high lighting band to "WIDE' item, then
push [ENTER],
3.Push [MAIN PAGE] to exit system setting.
Notes:three screen ratio modes, i, e, 16:9 WIDE, 4:3 PS, 4:3 L are
available for your selection to enable different discs to match TV.
the relationship between the video of disc and screen ratio mode
are as follows:
Video of disc normal
4:3
16:9 16:9

Example 2:Set sound mix output mode

1. Push [SETUP] to enable TV screen display system setting
menu picture, push [DOWN] to move the high lighting band to the
item "SPEAKER SETUP", push [ENTER], TV screen will display
2. Push [RIGHT] to enter the sub-menu in the right screen, If you
want to set the sound mode to "STEREO", firstly push [DOWN]
4:3PS 4:3LB 16:9
16
once to move the high lighting band to "STEREO" item, then
push [ENTER].
3,Push [MAIN PAGE] to exit system setting page.
Example 3: Coaxial output
If the user use coaxial terminal to output audio signal, you need to
set the audio output "SPDIF/RAW' or "SPDIF/PCM", you can
operate following these procedures:
Push [SETUP] to enable TV screen display system setting menu
picture, please firstly enter general setting sub-menu,then
select the item "AUDIO OUTPUT" in the menu, then push
[ENTER], TV screen will display:
AUDIO SETUP
AUDIO OUT ANALOG
OP MONO SPDIF/RAW
DUAL MONO SPDIF/PCM
DYNAMC
PRO LOGIC
LPCM OUTPUT
MAIN PAGE
DYNAMC RANGE COMPRESSION
2.Push [RIGHT] to enter the sub-menu in the right screen, push
[DOWN] to move the high lighting band to the item "SPDIF/RAW"
or "SPDIF/PCM",then push [ENTER].
3.Push [MAIN PAGE] to exit system setting.
Special indications: if you are not going to use coaxial output
audio signal, you need to set audio output to "ANALOG' output, so
there will be no audio signal to set audio output to "ANALOG"
output, so there will be no audio signal to be output in the
mixchannel.
17
System setting