Ariens 911396 Owner's/Operator's Manual page 13

Swivel Wheel Models (911330, 396,
525, 534)
To change front wheel cutting height, insert
height adjuster pin into the holes that match
the desired cutting height and fasten with key
ring (Figure 8).
To change rear wheel cutting height, move
cutting height levers one notch at a time to
set the desired cutting height.
High
Rear
Front
1. Cutting Height Lever
2. Height Adjuster Pin
3. Key Ring
Low
2
3
Figure 8
OPTIONAL CONTROLS
Primer Bulb (911086, 330, 396, 514,
525, 531, 532, 533, 534)
Push the primer bulb in to add fuel for easier
engine start.
Throttle (911102)
1
Speed Control (self-propelled
models)
Speed control rod changes the mower's
forward travel speeds.
OM0480
Start mowing slowly and use speed control
rod to gradually increase speed to a safe,
comfortable walking pace.
Speed control rod should hold the desired
OM1270
speed. If not, adjust speed control bell crank.
(See SPEED CONTROL BELL CRANK (self-
propelled models) on page 23.)
GB - 13
The throttle controls the
engine speed and chokes
1
engine for starting.
2
1.Start - Push lever all the way
forward.
2.Fast.
3.Slow - Pull lever all the way
rearward.
3
OL2074
High –Push rod all the way
forward.
Low –Pull rod all the way
rearward.