Preparing Cappuccino - Silvercrest SEM 1100 B3 Operating Instructions Manual

7) Once the cups are filled up to the required amount (about 20 ml per cup),
press the "Espresso" button
You can now drink the espresso.
8) Switch the appliance off with the on/off switch
NOTE
► If no button is pressed, the appliance turns off automatically after 30 minutes.
9) After every use, remove the used espresso powder from the espresso sieve
Remove the sieve holder
blocker
sieve carrier
holder
espresso powder out. Always dispose of the espresso powder in an environ-
mentally friendly manner, e.g. with the organic waste.
NOTE
► Clean the hot water shower
use. See also the section "Cleaning and Care".
NOTE
► Empty the drip tray
in the hole of the drip grille

Preparing cappuccino

WARNING
Be careful when working with steam for the milk froth production!
The hot steam or hot splashes can lead to injuries!
► Always operate the steam control
1) Fill a container for frothing (preferably made of stainless steel) to one third
with cold milk.
2) Ensure that the steam control
direction " - ").
3) Push the milk frother
■ 86 │ GB │ MT
from the appliance. To do this, fold the sieve
upwards so that the espresso sieve
. Now empty the espresso sieve
and the blocked espresso sieve
(the hot water comes out of this) after each
regularly, at the latest when the red float
.
out to the side. Always hold it by the handle
to stop the water being pumped through.
.
cannot fall out of the
over and knocking the
slowly.
is closed (turn it as far as it will go in the
.
by turning the sieve
is visible
.
SEM 1100 B3