12 BRAKE SYSTEM
12.12
104
A01180-10
A01266-10
A01180-10
Checking that the brake linings of the rear brake are secured
Warning
Danger of accidents Worn-out brake linings reduce the braking effect.
–
Ensure that worn-out brake linings are replaced immediately. (Your authorized Husqvarna Motorcy-
cles workshop will be glad to help.)
Preparatory work
–
Check that the brake linings of the rear brake are secured.
(
p. 104)
–
Remove the right side panel. (
Main work
–
Remove the cable ties.
–
1
Remove screw
with washer.
–
Push the right frame protector to the front and take off at the
bottom.
–
Stand the vehicle upright.
–
2
Remove screw cap
with membrane
–
Add brake fluid up to the marking
Brake fluid DOT 4 / DOT 5.1 (
–
Mount and tighten the screw cap with the membrane and O-
ring.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
–
Insert the right frame protector from below and push it to the
rear.
–
Mount and tighten screw
Guideline
Screw, frame pro-
tector
–
Mount the new cable ties.
Finishing work
–
Install the right side panel. (
p. 59)
3
and the O-ring.
A
.
p. 159)
1
with the washer.
M5
3 Nm (2.2 lbf ft)
p. 60)