Table of Contents
Advertisement
12 BRAKE SYSTEM
100
Info
Do not operate the hand brake lever if the brake
caliper has been removed.
–
Remove cotter pins
brake linings.
–
Clean the brake caliper and the brake caliper bracket.
J00009-10
–
Check that spring plate
pad sliding plate
correctly.
W00083-10
–
Insert the new brake linings, insert pin
5
pins
.
Guideline
Mount the outer cotter pins from the front to the rear.
Mount the inner cotter pins from the rear to the front.
Info
Always change the brake linings in pairs.
To make it easier to mount the pin, push the brake
J00009-10
linings against the retainer spring.
Make sure the brake linings and retainer spring are
seated correctly.
(All models apart from Rockstar Edition)
–
Position the brake caliper.
–
Mount and tighten screws
Guideline
Screw, front
brake caliper
–
Operate the hand brake lever repeatedly until the brake
linings are in contact with the brake disc and there is a
pressure point.
W00081-10
5
6
, pull out pin
, and remove the
7
in the brake caliper and brake
8
in the brake caliper bracket are seated
6
, and mount cotter
4
.
M8
25 Nm (18.4 lbf ft)
®
Loctite
243™
Advertisement
Table of Contents
