Pullman Holt Gloss Boss GB-1500X Operation & Care Instructions

"Gloss Boss" Burnisher GB-1500X
This 1500-RPM burnisher is a high quality, precision made product. All parts used in the
manufacturing of this burnisher have passed rigid quality control standards prior to assembly,
and an "each unit" final inspection prior to packaging is your assurance of proper assembly.
This burnisher was protectively packed to prevent possible damage in transit. Should damage
occur, please notify the transporting carrier immediately for loss and/or claim.
GROUNDING:
This burnisher must be grounded while in use to protect the
operator from electric shock. The burnisher is equipped with
an approved three-conductor cord and three-prong grounding
type plug to fit the proper grounding type receptacle. The
green (or green and yellow) conductor in the cord is the
grounding wire. Never connect the green (or green and yellow)
wire to a live terminal.
If your unit is for use on less than 150
volts, it has a plug like that shown in
Figure A.
If it is for use on 150 to 250 volts, it has a
plug like that shown in Figure D.
An adapter (Figures B&C) is available for connecting Figure A
plugs to two-prong receptacles. The green-colored rigid ear,
lug etc., must be connected to a permanent ground such as a
properly grounded outlet box. No adapter is available for a
plug as shown in Figure D. Adapter shown in Figure B & C is
not for use in Canada.
WARNING
RISK OF FIRE. Do not use with a flammable
or combustible liquid to clean a floor.
Operation & Care Instructions
Save For Future Reference

IMPORTANT SAFEGUARDS

MOTOR:
This burnisher is powered by a 1-1/2 HP AC motor. Be sure
your power supply agrees with the voltage marked on the
name plates. A voltage decrease of more than 10% will cause
the motor to slow down, thus increasing the current draw and
opening the circuit breaker.
EXTENSION CORDS:
Burnishers that have 3 wire cords requiring grounding must
only be used with extension cords that have 3-prong
grounding type plugs and 3-pole receptacles.
To determine the minimum wire size required, refer to the
chart below:
Minimum Wire Size (AWG) of Extension Cord
Nameplate Total Extension Cord Length (Feet)
Rating-Amps 25 50
0-10.0 18 18
10.1-13.0 16 16
13.1-15.0 12 12
Before using an extension cord, inspect it for loose or exposed
wires, damaged insulation and defective fitting.
CAUTION
Always disconnect power cable from outlet
when working on this burnisher.
75 100 125 150 175 200
16 16 14 14 12
14 14 14 12 12
12 12 12 12 12
12
12
–