Advertisement
TO ADJUST HANDLE:
This burnisher is packaged with the handle folded forward and
the foot pedal in the up position.
1. Depress the foot pedal then raise the handle until the open-
ing in the bottom of the handle is centered over the handle
lock.
2. Return the foot pedal to the up position, which allows the
center lock to position inside the handle. The handle is now
LOCKED for travel.
3. When ready to operate, depress the foot pedal, then lock by
pushing forward. The handle is now FREE FLOATING.
Note: The handle on this burnisher MUST BE FREE FLOATING
to permit proper operation.
TO ATTACH PAD:
1. With handle locked in the upright position, tilt burnisher
back on the handle until the underside is fully exposed.
2. Remove the plastic pad lock by turning clockwise.
3. Install pad.
4. Lock center device by turning counter-clockwise.
NOTE: Never Operate the Burnisher without a pad.
ABOUT THE MACHINE
10702 N 46th Street • Tampa, FL 33617
(813)971-2223 • toll free (800) 237-7582
fax (813) 971-6090 • order entry fax (800) 833-8875
www.pullmanholtcorp. com
TO START:
The normal position of this burnisher, with the pad stationary,
is tilted back on the four wheels with the pad off the floor.
1. Remove cable completely from cable hooks.
2. With the handle in free float position and the power cable
plugged into the proper outlet, squeeze the switch bar
beneath the handle grips.
3. As the motor reaches full speed (1-2 seconds), the pad will
slowly fall to the floor due to the partial vacuum between
the pad and the floor created by the high speed pad rota-
tion.
TO OPERATE:
For best result, use a clean pad and change frequently as pad
loads up. A motor overload could result from a dirty, loaded
pad. If the built-in circuit breaker trips, wait five (5) seconds,
then depress button on the side of the switchbox. Change the
pad.
Operate the burnisher in a straight-line path. Avoid continuous
operation in one spot, as such operation may damage the floor.
CARE AND MAINTENANCE:
This burnisher will afford you may years of trouble-free service
provided it is given proper care. Throwing, dropping bumping
across the thresholds and other misuse may result in a
damaged unit and invalidate the warranty. When storing your
burnisher, always remove the pad. Pads can be cleaned by
washing in warm water with mild detergent, rinsing, and hung
up to dry.
It is not necessary to lubricate this burnisher. All bearings have
been pre-lubricated and permanently sealed at the factory.
B703523 1/04
Advertisement
