Table of Contents
Advertisement
EVA Expandable Vertical Array
A
B
Figure 7.7: Use of two EVA-SG2 standard grids
Notice!
i
When using two grids, the angle between the suspension lines must never exceed 60°. Do not
use EVA-CG (discontinued), EVA-EG or EVA-EG2 grids in this application.
For overall down angles of about 45° or greater:
4
For overall down angles of less than about 45°:
1.
2.
7.2.5
EVA-1151D tie plates
Every EVA-1151D module (discontinued) includes tie plates.
Features
–
–
–
An EVA-GXB spreader bar at the top of an EVA-1151D module (discontinued) serves as a
rudimentary flying grid for a stand-alone subwoofer hang, if only minimal down angle is
required.
Electro-Voice
A EVA-SG2 standard grid
Use the third-to-last hole of each grid.
Use the third-to-last hole on the bottom grid.
Use any hole forward of third-to-last on the top grid.
Assembly of multiple EVA-1151D modules (discontinued) in a vertical column at either 0°
or 5° of splay between modules.
Provision of attachment points for suspending EVA-2082S modules underneath.
Installation of an optional EVA-GXB spreader bar at the top of an EVA-1151D module
(discontinued) by inverting the tie plates.
60º MAX
B EVA module(s)
Installation manual
Rigging system | en
27
A
2023-01 | 04 | F01U196199
Advertisement
Table of Contents
