Mitsubishi Electric 800 Series Instruction Manual page 23

NOTE
• Do not tilt the terminal block while tightening the screws or removing it from the inverter. (Otherwise, stress applied to the
control circuit terminal block or the control circuit connector may damage the pins.)
• After replacing the control terminal block, set the control logic switch to the correct position in accordance with the control
logic of input signals. (Refer to the FR-E800 Instruction Manual (Connection).)
• When the control circuit terminal block is not connected to the inverter properly, a board combination fault (E.CMB) occurs.
INSTALLATION AND WIRING
2
23