Table of Contents
Advertisement
Under Full Screen Mode, select Full Screen Face Card, then click OK.
5.
6.
Click
to enter Full-Screen Mode.
Temperature Configuration
Navigate to All Features > Temperature Monitor > Temperature Config.
1.
2.
Set the preset values to acceptible body temperatures and alarm trigger temperatures. All these
settings are based on your systems regulations.
3.
Low Temperature Threshold represents the lowest temperature in the readible range. Body
temperatures below this temperature are considered invalid and will not be recorded or displayed.
The default value is 35 °C.
4.
The high temperature threshold is the upper limit of the readible range. A body temperature
higher than this temperature value is regarded as invalid and will not be recorded or displayed.
The default value is 45 °C.
5.
Alarm interval is the time between two consecutive alarms. The default value is 60 seconds.
6.
Normal Body Temperature is the interval of accecptable body temperatures. Detected body
temperatures in this interval will not trigger an alarm. If the temperature drops below or exceeds
this interval, an alarm will be issued. The default range is between 36.5 °C to 37.8 °C.
After all values have been set, click Apply to save your settings.
7.
14
DCS-9200T Quick Installation Guide
Advertisement
Table of Contents
