Fisher & Paykel DD60DA9 Installation Manual page 15

1
2
3
INSTALL TOE KICK – DD60DA MODELS
Measure the distance from the floor to
the base of the lower door panel. Refer
to the table below for the recommended
cut location.
0
HEIGHT FROM FLOOR TO
CUT
1 BASE OF DOOR (MM)
2
3
3
2
1
0
*recommendations are based on the required min.
clearance of 12mm between the floor and toe kick.
On a protected surface, carefully score
down both corners to the desired cut-
off point and snap to remove the excess.
Once the sides are removed, score down
the middle of the toekick and snap
to remove.
Smooth the edges using a file or knife
as desired.
5
100 – 114
115 – 129
130 – 144
6
145 – 160
If the toe kick touches the floor with a full load, more of the panel may need to be removed.
1 Remove the lower drawer. Refer to 'Secure to cabinetry via drawer removal (method B)' for
considerations and guidance.
2 Remove the pins securing the toe kick to the DishDrawer using a pair of needle nose pliers
to press the pin legs together and push back through the mounting holes.
3 Remove toe kick and cut off an additional section referring to the guidance on this page.
4 Refit the lower drawer. Refer to 'Secure to cabinetry via drawer removal (method B)' for
considerations and guidance.
5 Refit the toe kick panel referring to the guidance on this page.
Punch or drill out the two mounting
holes with a 5mm drill bit on each side
of the toe kick as shown.
Secure toe kick to the Dishdrawer using
the supplied pins.
15