iRobot Roomba j6+ Owner's Manual page 14

Cleaning the Visual Docking Target
Sensors and Charging Contacts
1
Wipe sensors and charging contacts with
a clean dry cloth. You can alternately use
a pad of melamine foam to remove built
up debris on the robot and CleanBase
charging contacts.
2
Inspect the visual docking target and
charging contacts to make sure that
they are clear of debris. Wipe with a
clean, dry cloth.
Replacing the Bag
1
Lift up on the canister lid to open.
2
Pull up on the plastic card to remove the
bag from the canister.
Note: This will seal
Note: Do not
the bag so dust
spray cleaning
and debris cannot
solution
escape.
directly onto
sensors or
into sensor
openings.
3
Discard the used bag.
4
Install a new bag, sliding the plastic card
into the guide rails.
5
Press down on the lid making sure that it
is completely closed.
Note: To achieve optimal performance with your
robot and automatic dirt disposal, clean and/or
replace your robot's filter as needed.
Roomba j6+ Owner's Guide
®
EN
9