Bagging The Clippings; Side-Discharging The Clippings - Toro TimeMaster 21200 Operator's Manual

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf clippings from the lawn.
If the side-discharge chute is on the mower, remove it before bagging the clippings; refer to
Side-Discharge Chute (page
Installing the Grass Bag
1. Raise and hold up the rear door (A of
2. Remove the rear-discharge plug by pulling down on the latch with your thumb and pulling the plug out
from the machine (B of
3. Install the bag rod into the notches at the base of the handle and rock the bag back and forth to ensure
that the rod is seated at the bottom of both notches (C of
4. Lower the rear door until it rests on the grass bag.
Removing the Grass Bag
To remove the bag, reverse the steps in

Side-Discharging the Clippings

Use the side discharge for cutting very tall grass.
If the bag is on the machine, remove it and insert the rear-discharge plug; refer to
(page 20) before side-discharging the clippings.
Important:
Ensure that the rear-discharge plug is in place before you recycle the clippings
Installing the Side-Discharge Chute
1. Lift open the side-discharge door (A of
2. Install the side-discharge chute and close the door onto the chute (B and C of
21).
Figure 24).
Figure 24).
Figure 24
Installing the Grass Bag (page
Figure
Figure 24)
20).
25).
20
Removing the
Removing the Grass Bag
(Figure
Figure 25).
g234922
23).