Subscribe to Our Youtube Channel
Related Manuals for Profile MP9900
Summary of Contents for Profile MP9900
- Page 1 INSTALLATION INSTRUCTIONS / OWNER S MANUAL MP9900 AM/FM HIGH POWER FLIP DOWN DETACHABLE FACE CD/USB/MMC/MP3 PLAYER...
- Page 2 NTRODUCTION Congratulations on your purchase of a Profile state-of-the-art single disc MP3/CD and MMC/USB player. Your selection of a Profile car audio product indicates a true appreciation of fine musical reproduction. Whether adding to an existing system or including your Profile MP3/CD player in a new system, you are certain to notice immediate performance benefits.
-
Page 3: Safety Precautions
To avoid the possibility of power, signal or speaker shorts, be careful not to allow the amplifier wires to come in contact with sharp edges. Use a grommet to protect the wire when running through the fire wall . MP9900... -
Page 4: Care And Maintenance
Cleaning the CD player When cleaning the vehicle, be sure not to get any water in or on the CD player. Clean only the exterior surface of the unit with a dry, clean soft towel using no chemical solvents. Operating in extreme temperatures Sometimes the unit will not operate in extreme, hot or cold temperatures. - Page 5 Do not expose the disc to direct sunlight which can cause the disc to warp. Always store the disc in its case for protection. Scratched up discs will produce poor sound performance and cause CD player to skip. Label surface up MP9900...
- Page 6 LECTRICAL AND SIGNAL CONNECTIONS Before making the following connections, take time to look over the vehicle's wiring and determine the location and wires you will be connecting to. If you do not wish to cut or tap into the vehicles existing factory wiring, there are wiring kits available at your car audio retailer that will allow you to plug directly into the factory wiring harness.
- Page 7 Low level (RCA) signal output for connection to amplifier or signal processors. ISO SOCKET - Not Used - Not Used Front Right Speaker (+) Front Right Speaker (-) Front Left Speaker (+) Front Left Speaker (-) - Not Used - Not Used MP9900...
- Page 8 There are two different ways to mount the CD Player. In most Japanese vehicles you can use the factory mounting brackets, taking advantage of the ISO/DIN opening. If your vehicle does not have ISO/DIN opening, you can mount the CD Player using the supplied DIN sleeve and rear support bracket.
- Page 9 3 Then push up the face plate until it clicks into proper position. Once the CD player is secured, fit the trim ring over outside edge of the radio until it snaps into place. FACE PLATE MP9900...
-
Page 10: Iso/Din Mounting
If you own a Japanese vehicle, you can use the standard ISO/DIN mounting screw holes on the side of the CD player to attach to the existing factory mounting bracket, without using the provided DIN sleeve. Remove the factory ISO/DIN mounting bracket from the car along with the factory radio. Remove the factory radio from the bracket by unscrewing the two Phillips screws on each side of the radio paying close attention to their screw positions and saving the screws to mount the CD player. -
Page 11: Location And Function Of Controls
LOCATION AND FUNCTION OF CONTROLS MP9900... -
Page 12: Disc Play
POWER To turn “ON” the unit, press any button except the OPEN button. To turn “OFF” the unit, press the POWER ( 2 OPEN Press the OPEN( ) button to flip down the face plate. This will allow you to insert or eject a CD and also remove the face plate. - Page 13 Beep, Preset EQ, Last Volume, and Clock Format. 7 or 8 button momentarily and repeatedly to 7 or button to increase the volume and press BASS (Bass) (Treble) (Balance) 7 or 8 button momentarily and 7 or 8 button to fast (Fader) MP9900...
- Page 14 Beep - The unit is equipped with BEEP ON, BEEP OFF functions. Push the SEL 9 button for more than 2 seconds to display BEEP ON/OFF. Then rotate the VOL 9 knob to choose between BEEP ON and BEEP OFF modes. BEEP ON mode: The beep sound is generated when any button is pressed.
- Page 15 6 strong signaled stations for that band and stores them into the preset memory. For other FM or AM bands, it’ll briefly display each preset stations. 11 button to pause 11 button for more than 2 MP9900...
-
Page 16: Radio Scan
18 MUTE Press the MU 18 button to mute the system. Press a second time to resume listening. 19 LOUD Press the LOU 19 button once to enhance the bass effect. Press again to cancel the loudness function. 20 MONO/STEREO Monaural (Mono) or Stereo mode can be selected for FM tuner’s reception. -
Page 17: Auxiliary Input Jack
Note: Never remove an MMC/SD card while the music is being played. Always switch to a different mode by pressing MODE 5 button. If not, it may damage the MMC/SD card and/or cause the unit to lock up. MP9900... -
Page 18: Maintenance Of Remote Control
AINTENANCE OF REMOTE CONTROL Before using the remote control, the insulating patch must be removed. This patch was installed to insulate the battery from draining until ready to use. BATTERY INFORMATION: Lithium Battery: CR2025 3V Battery Life: Approximately 6 months. Replacing the Battery from the Remote Control: 1) Turn over the remote control so the rear side of the remote is facing up. -
Page 19: Troubleshooting The System
The following chart will help in solving most problems that may occur. Should any problem persist after you have made these checks, please consult your nearest Profile retailer. Before going through this check list, refer back to the wiring and operating procedures. - Page 20 SYMPTOM CAUSE The compact The installation angle is disc skips. greater than 30 degrees The disc player is installed incorrectly The compact disc is extremely dirty or defective disc. Condensation build-up on the inside of the unit. The radio The antenna is not does not connected or the antenna is work.
-
Page 21: Specifications
Usable Discs...MP3/CD/CD-R/CD-RW Discs RADIO Frequency Coverage...87.5 to 107.9MHz(US) IF...10.7MHz Station Presets...18 Frequency Coverage...530 to 1710KHz(US) IF...450KHz Station Presets...12 Due to continuing product improvement, specifications subject to change without notice. PECIFICATIONS || || || || || || (D) x 2 (H) MP9900... -
Page 22: Limited Warranty
One (1) Year from the date of sale to the original consumer purchaser. If this product is proven to be defective within this one year period, Profile will repair it when said product is returned, with a copy of the dated sales receipt, freight prepaid to Profile. -
Page 23: Warranty Repair Policy
4) Include a brief description of the problem or failure with the unit. 5) Include the return street address and daytime telephone number. 6) Allow 2~3 weeks for repair (this period includes shipping time). Send unit to: PROFILE CONSUMER ELECTRONICS, INC. 15060 SHOEMAKER AVE SANTA FE SPRINGS, CA 90670 TEL: (562) 404-9393... - Page 24 PROFILE CONSUMER ELECTRONICS, INC. 15060 SHOEMAKER AVE SANTA FE SPRINGS, CA 90670 TEL: (562)404-9393 FAX: (562)404-9433 WWW.PROFILEUSA.COM...
Need help?
Do you have a question about the MP9900 and is the answer not in the manual?
Questions and answers