Am/fm high power detachable face cd player (21 pages)
Summary of Contents for Profile PCD970R
Page 1
INSTALLATION INSTRUCTIONS / OWNER S MANUAL PCD970R AM/FM HIGH POWER FLIP DOWN DETACHABLE FACE CD PLAYER...
Page 2
Congratulations on your purchase of a Profile state-of-the-art single disc CD player. Your selection of a Profile car audio product indicates a true appreciation of fine musical reproduction. Whether adding to an existing system or including your Profile CD player in a new system, you are certain to notice immediate performance benefits.
AFETY PRECAUTIONS Secure the CD player When installing your CD player in the vehicle, make sure it is mounted properly in the dash, using an after market installation kit if needed. When using the supplied mounting sleeve, it is a must that you also use the supplied back brace to support the back of the CD player.
Cleaning the CD player When cleaning the vehicle, be sure not to get any water in or on the CD player. Clean only the exterior surface of the unit with a dry, clean soft towel using no chemical solvents. Operating in extreme temperatures Sometimes the unit will not operate in extreme, hot or cold temperatures.
Page 5
Do not expose the disc to direct sunlight which can cause the disc to warp. Always store the disc in its case for protection. Scratched up discs will produce poor sound performance and cause CD player to skip. Label surface up...
Page 6
! The blue wire is connected only if a power antenna or an amplifier is used in the system. This wire supplies +12 Volt output when the CD Player is turned on, which activates most power antenna relays or amplifier turn on circuits.
Page 7
Low level signal output for connection to amplifier or signal processors. FRONT RCA OUTPUT R CH RED BLACK L CH WHITE REAR RCA OUTPUT R CH RED GRAY L CH WHITE GRAY FRONT RIGHT SPEAKER GRAY/BLACK NOT USED NOT USED PCD970R...
Page 8
When considering your mounting location, make sure the unit will be leveled. If you cannot mount the CD Player level, due to your vehicles design, make sure there is no more than a 30 degree tilt. Keeping this in mind will assure proper CD play and overall reliability.
Page 9
3 Finally push up the face plate until click sound is heard. Once the CD player is secured, fit the trim ring over outside edge of the radio until it snaps into place.
Page 10
CD player to the factory ISO/DIN bracket using the screws that you removed from the factory radio. Connect the wire harness and antenna plug to the back of the CD player. Then mount the factory ISO-DIN bracket to the car.
1 POWER To turn ON the unit, press any button except the OPEN button. To turn OFF the unit, press the PWR button for more than 2 seconds. 2 FLIP DOWN PANEL Press the OPEN button to flip down the face plate. This will allow you to insert or eject a CD and also remove the face plate.
8 or 9 button momentarily and repeatedly to 8 or 9 button to move to the next or previous track. 8 or 9 button to fast forward or fast (Bass) (Treble) (Balance) 8 or 9 button to speedily (Fader) PCD970R...
Page 14
Press the SEL button for more than 2 seconds to display additional set of functions for adjustments, such as DSP, Beep On/Off, Seek 1 or 2 , Clock 12 or24, and Volume Last/Adjust. DSP - The unit is equipped with 4 preset equalization modes. Press the SEL button for more than 2 seconds to display DSP OFF.
Press the ST button to select between Mono and Stereo modes. 12 button to pause CD play. Press again to 12 button for more than 2 seconds to go back PCD970R...
Page 16
20 CLOCK Press the CLK button to display the time on the LCD for 5 seconds. To adjust the time, press and hold the CLK button until the hour flashes and use the VOL 5 knob to adjust the hour. Press and hold the CLK button again until the minute flashes and use the VOL 5 knob to adjust the minute.
4) Gently push in the holder until securely locked into place. WARNING: Do not recharge, disassemble or dispose of in fire. Battery leakage may cause damage to the unit. To avoid the risk of accident, keep batteries out of reach of children. side facing up. PCD970R...
The following chart will help in solving most problems that may occur. Should any problem persist after you have made these checks, please consult your nearest Profile retailer. Before going through this check list, refer back to the wiring and operating procedures.
Page 19
Leave the disc player off and turn the vehicle's air conditioner on to remove the condensation build-up inside the unit. Check the antenna and connection to insure proper performance. Select stations manually and make sure the tuner is in the distant stereo mode. PCD970R...
RMS Output Power...30W x 4 Maximum Current Consumption...15 Ampere Fuses Memory (Constant)...15 Ampere Accessory (Switched)...0.5 Ampere RCA line out voltage...3.7 V CD PLAYER Signal to Noise Ratio...>85dB Channel Separation...>80dB Frequency Response...5Hz ~ 20Khz Usable Disc...CD/CD-R/CD-RW Discs RADIO Frequency Coverage...87.5 to 107.9MHz(US) IF...10.7MHz...
One (1) Year from the date of sale to the original consumer purchaser. If this product is proven to be defective within this one year period, Profile will repair it when said product is returned, with a copy of the dated sales receipt, freight prepaid to Profile.
4) Include a brief description of the problem or failure with the unit. 5) Include the return street address and daytime telephone number. 6) Allow 2~3 weeks for repair (this period includes shipping time). Send unit to: PROFILE CONSUMER ELECTRONICS, INC. 15060 SHOEMAKER AVE SANTA FE SPRINGS, CA 90670 TEL: (562) 404-9393...
Need help?
Do you have a question about the PCD970R and is the answer not in the manual?
Questions and answers