Mosa RENTAL Use And Maintenance Manual page 29

ATS - AFTER TREATMENT SYSTEM
KOHLER
DISPLAYING THE AFTER-TREATMENT STATUS
The gen- set's controller provides information on the after-
treatment system installed on the generator engine by the
functions:
• display of universal lamps (icons)
• display of analogue and binary values
• control of the aftertreatment regeneration function by
command transmission to the ECU
After-treatment screen
The after-treatment screen is displayed automatically once one
of the selected lamps turns on or changes state. Deactivating
the lamp will not trigger the screen display.
The screen is then shown until the operator switches to
another screen. The alarm list screen has a lower priority, so
even if a new alarm appears, the After-treatment screen is still
displayed.
To avoid displaying a blank screen, inactive lamps are
represented by 'dotted' icons, if no lamps are active the screen
shows all dotted icons. See examples below:
Universal lamps (icons)
Universal lamp icons are shown on the After-Treatment
screen. Depending on the specific value read in a specific
facility with a specific SPN, each lamp icon is:
shown - hidden - slow flashing (1 Hz) - fast flashing (2 Hz)
Note: The flashing lamp icon is defined as the display of
the active lamp icon and the inverted active lamp icon in the
required frequency.