Sony DVCAM DSR-200AP Operating Instructions Manual page 75

Editing onto another tape
Starting editing
(1) Set the POWER switch to ON and then set CAMCORDER/PLAYER to
PLAYER.
(2) Insert a blank tape (or a tape you want to record over) into the recording VCR.
Then insert your recorded tape into the digital camcorder.
(3) Play back the recorded tape on the digital camcorder until you locate the point
where you want to start editing. Then set the digital camcorder to playback
pause mode.
(4) Set the recording VCR to recording pause mode.
(5) Press P on the digital camcorder and VCR simultaneously to start editing.
To edit more scenes, repeat steps 3 to 5.
To stop editing
Press π on the digital camcorder and VCR.
Note on editing when using the A/V connecting cable
Press DISPLAY on the Remote Commander while editing onto another tape to turn off
the display indicators. Otherwise, the indicators will be recorded on the tape.
Note on Fine Synchro Edit
If you connect a video deck that has the Fine Synchro Edit feature to the l LANC jack
of the digital camcorder using a LANC cable (not supplied), the edit will be even more
precise.
75