Advertisement
Step 3A 'Wood Stud Option
A\ WARNING:
@®Avoid potential personal injury or property damage! DO NOT over-tighten the lag screws
[W-A] and washers [W-B]. Tighten the lag screws [W-A] only until the washers [W-B] are
pulled firmly against the arm assembly/wall plate [01].
@®DO NOT USE ANCHOR
[w-C] FOR THIS STEP
@ Stud center must be verified
Use a stud finder(not included)
to locate wood studs or use an
awl (not included) to verify the
edges. Mark the edge and
center locations.
Awl
(Not Included)
Position the arm assembly/wall plate
[01] at your desired height and line
up the holes with your stud center
line. Level the arm assembly/wall
plate [01] and mark the holes.
e
2
You may need
assistance with this step.
\s
07
Drill 3 pilot holes using a 5/32 in.(4 mm)
diameter drill bit. Make sure the depth is
not less than 2 11/64 in.(55mm).
2 11/64 in.(55mm)
85/32 in.(4mm)
Install the arm assembly/wall plate
[01] using lag screws [W-A] and
washers [W-B]. Tighten the lag
screws [W-A] only until the washers
[w-B] are pulled firmly against the
wall plate.
2
You may need
assistance with this step.
3/8 in.(10 mm)
Socket Wrench
(Not Included)
08
Advertisement
