Marine PC MIL-Spec MPC-ML2 D Series User Manual page 21

Source Menu Parameters
A check in a box indicates an enabled signal source attached to the Monitor.
Deselecting the box disables the Monitor's ability to display the signal.
Video 1 - Composite
• Open the "Video1" function, and
• Press the UP or DOWN buttons to enable (ON) or disable (OFF) the Video 1 source.
Video 2 –
INACTIVE or, if connected, as above.
Video 3 -
INACTIVE or, if connected, as above.
PC - VGA
• Open the "PC" function, and
• Press the UP or DOWN buttons to enable (ON) or disable (OFF) the PC source.
OSD Menu Parameters
OSD H-Position
• Open the "OSD H-Position" function, and
• Press the UP or DOWN buttons to adjust the horizontal position for the OSD menu
on the Display.
OSD V-Position
• Open the "OSD V-Position" function, and
• Press the UP or DOWN buttons to adjust the vertical position for the OSD menu on
the Display.
OSD Duration
• Open the "OSD Duration" function, and
• Press the UP or DOWN buttons to adjust the time elapse between the last menu
activity and when the menu disappears. The range is between 0 and 100 seconds;
factory default is 15 seconds.
Set-up Menu Parameters
AUTO Power
• Select "AUTO Power" function if user wants system data (channel, signal source)
saved when the system is powered off.
Reset
• Select "Reset" function, and
• Select "YES" to automatically adjust picture data to default such as: brightness,
MPC-ML2D-UM(B) 10/2015
21