Marine PC MIL-Spec MPC-ML2 D Series User Manual page 12

There are three mounting holes in the back of the Monitor for the ball mounting plate.
Take care not to strip the screw holes or over tighten. (Figure 4)
• Line up one of the ball mounting plates on these three holes (Figure 4)
• With three (3) M4 x 10 counter-sunk stainless screws attach this mounting plate to the back of
the MPC-MLD.
• Mount the second ball mounting plate where the Monitor shall be installed
• Insert each ball into the RAM arm
• Lightly tighten the arm around the balls using the T-knob on the arm (Figure 2, 4)
• Adjust the Monitor to the viewing preference, and
• Tighten the T-knob to hold the Monitor in position.
It is recommended the remaining ball be mounted on a flat surface. Because of the
various surface substrates the Monitor shall be mounted on, the installer shall provide
the screws to mount the other ball.
Surface Panel Mount
The Panel Mount installation should be specified at the
time of order; the ball-and-socket mount system will not be
included in the shipping box.
The mounting hardware packet is included with the unit
accessories in the shipping box. This packet includes four (4)
threaded screws (approximately 7.6 cm [3"] long), four (4)
Nylock nuts and four (4) flat washers. For installation, there
are four tapped mounting holes on the four corners of the
unit's rear panel. The 15" contains 6 each.
It is recommended the installer refer to the mount draw-
ings on MarinePC's web site, with (link address listed in
Appendix A) for the exact measurements of the unit's rear
panel pod. These should be helpful when the installer cuts
the required space for the Panel Mount installation.
Take care not to strip the
screw holes or over tighten
as the enclosure is aluminum.
CAUTION!
12
MPC-ML2D-UM(B) 10/2015
Figure 5