Toro 72098 Operator's Manual page 64

Note:
Do not pull the wing decks into the
operating position in order to remove the cylinder
pins.
1. Cylinder rod end
2. Cotter pin
12. Remove and retain the bolts that secure the
upper pivot pins to the deck and then remove
the pivot pins (Figure
1. Upper pivot pins
2. Bolt
13. Pull the wing deck outward to separate it from
the center deck section
14. Remove the flanged bushings from the upper
pivot points and clean the bore
Figure 84
3. Cylinder pin
85).
Figure 85
3. Pull outward
4. Left wing deck
(Figure 85).
(Figure
1. Upper pivot point bushing
2. Lower pivot point bolt
15. Apply a thin bead of Loctite
circumference of the rear edge of the new
bushings.
16. Insert and gently tap the new bushings into the
g350948
opening and properly seat them into place.
17. Place a block of wood under the inside edge of
the center deck to make it easier to work on the
lower pivot point bushings.
18. Remove and retain the lower pivot point bolts
(Figure 83
19. Remove and discard the flanged bushing from
the front and rear of the wing deck and clean
the bore.
20. Apply a thin bead of Loctite
circumference of the rear edge of the new
bushings.
21. Insert and gently tap the new bushings into the
opening and properly seat them into place.
22. Install the lower deck pin assemblies and bolts
into the lower deck pivot points and hand-tighten.
23. To ease installing the wing deck sections,
carefully remove the exposed end of the spring
that applies pressure to the rear of the wing
g351309
deck cover
86).
64
Figure 86
3. Deck pin assembly
4. Bushing
® 680 to the entire
and Figure 86).
® 680 to the entire
(Figure 87).
g351363