Table of Contents
Advertisement
Hold the switch down until both wings are
completely folded.
2.
Position the mower to the 102 mm (4 inches)
height-of-cut position.
3.
Unlock the left and right wing deck cam locks
(Figure
77).
4.
Remove and retain the wing deck height-of-cut
lanyard
(Figure
77).
1. Cam lock
2. Clevis pin
5.
Insert the height-of-cut pin into the 102 mm (4
inches) location and install the lanyard.
6.
Lock the each wing deck cam lock.
7.
Start the engine.
Note:
The parking brake must be engaged and
the motion-control levers must be out to start
the engine. The operator does not have to be in
the seat. Ensure that all persons are clear of
the deck wings.
8.
Press and hold the front of the deck-lift switch
until the center deck lowers and both wings are
completely unfolded to the cutting height.
9.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
10.
Measure from the level surface to the front tip of
the left and right center deck blades
The measurement should read 102 mm (4
inches).
Figure 77
3. Lanyard
(Figure
g239055
1. 108 mm (4-1/4 inches)
2. Rear blade tip
3. Front blade tip
4. 102 mm (4 inches)
5. Level surface
Adjusting the Center Deck
1.
To increase the cutting height, turn the
adjuster screw clockwise; to decrease, turn it
counterclockwise.
Loosen the jam nuts on the top of each deck
adjuster. Fine-tune the adjuster on the front
deck-lift assembly by turning it to get the correct
height for the left and right, front blade tips on
the center deck
2.
Measure the rear tip height.
Fine-tune the rear adjusters as required. You
78).
can adjust the single-point adjustment to gain
more adjustment.
3.
Measure until all 4 sides are at the correct
height.
4.
Tighten all the nuts on the deck-lift arm
assemblies.
5.
If the 4 deck adjusters
enough adjustment to achieve the accurate
60
Figure 78
(Figure
79).
(Figure
79) do not have
g239092
Advertisement
Table of Contents
