Table of Contents
Advertisement
Alarm
If an error occurs, an error message displays, the LED
turns red, and the alarm sounds audibly as follows:
•
A fast chirp sound indicates critical errors.
•
A slow chirping sound indicates less critical errors,
such as required maintenance or service intervals.
Note:
During startup, the alarm sounds briefly to
verify functionality.
Refer to the Software Guide for more information.
Hour Meter
The hour meter records the number of hours the
engine has operated. It operates when the engine
is running. Use these times for scheduling regular
maintenance
(Figure
5).
Hours are displayed in Engine-Off screen or in the
Engine Hour Counter menu.
Refer to the Software Guide for more information.
Key Switch
Use this switch to start the engine. It has 3 positions:
S
, R
, and O
.
TART
UN
FF
Note:
The LCD indicators appear when each control
meets the "safe to start" mode (e.g., the indicator
turns on when you are in the seat.)
Note:
The engine ECU controls the glow plugs during
cold starts. If the coolant temperature is too low, the
glow symbol displays on the monitor and the starter
does not crank when you turn the engine to the S
position. The glow plugs activate in the O
position. Once the glow has been on long enough
for the current temperature, the glow symbol on the
monitor disappears and the engine cranks when
turned to the S
position.
TART
Note:
The system allows you to start the machine the
with the PTO switch engaged, but does not engage
the blades. You must reset the PTO to engage the
PTO.
Throttle Control
The throttle controls the engine speed, and there are
3 speeds: Maximum, Efficient, and Low.
Refer to the Software Guide for more information.
Blade-Control Switch (Power
Takeoff)
The blade-control switch (PTO) engages and
disengages power to the mower blades
The LCD indicator appears on the information screen
when the PTO switch is disengaged.
Note:
Monitor have a clutch saver, which allows the throttle
to automatically reduce the engine speed when
you disengage the PTO switch. Engaging and
disengaging the PTO switch changes the engine
throttle between the M
Note:
with the PTO switch engaged, but does not engage
the blades. Engaging the PTO requires you to reset
the PTO switch by disengaging, then engaging it.
Important:
before you can engage the PTO.
Deck Lift and Wing Deck
Fold/Unfold Switch
Press the switch rearward to raise the center deck
and to fold the wing decks.
Press the switch forward to lower the center deck and
to unfold the wing decks.
Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction
TART
or S
N
TART
Neutral-Lock Position
Move the motion-control levers outward from the
center to the N
the machine
motion-control levers into the N
when you stop the machine or leave it unattended.
Parking-Brake Lever
Whenever you shut off the engine, engage the parking
brake to prevent accidental movement of the machine.
15
Machines equipped with the Horizon Display
and T
OW
The system allows you to start the machine
You must unfold the wing decks
-
position when exiting
EUTRAL
LOCK
(Figure
24). Always position the
(Figure
5).
modes.
RANSPORT
(Figure
4).
-
position
EUTRAL
LOCK
Advertisement
Table of Contents
