Yamaha GRIZZLY 700 2013 Owner's Manual page 149

3. Remove the battery holding plate by removing
the nuts.
4. Disconnect the negative battery lead first,
then the positive battery lead by removing
their bolt. NOTICE: When removing the bat-
tery, the main switch must be off, and the
negative lead must be disconnected be-
fore the positive lead.
1
2
1. Battery holding plate
2. Nut
3. Negative battery lead (black)
4. Positive battery lead (red)
5. Pull the battery out of its compartment.
[ECB01001]
4
3
To charge the battery
Have a Yamaha dealer charge the battery as soon
as possible if it seems to have discharged. Keep in
mind that the battery tends to discharge more
quickly if the ATV is equipped with optional electri-
cal accessories.
ECB00931
NOTICE
To charge a VRLA (Valve Regulated Lead Acid)
battery, a special (constant-voltage) battery
charger is required. Using a conventional bat-
tery charger will damage the battery.
To store the battery
●
If the ATV will not be used for more than one
month, remove the battery, fully charge it, and
then place it in a cool, dry place.
●
If the battery will be stored for more than two
months, check it at least once a month and fully
charge it if necessary.
ECB00940
NOTICE
Always keep the battery charged. Storing a dis-
charged battery can cause permanent battery
damage.
8-57
8