Yamaha GRIZZLY 700 2013 Owner's Manual page 135

1
1. Tailpipe bolt
2. Remove the tailpipe by pulling it out of the
muffler, and then remove the gasket.
3. Tap the tailpipe lightly, and then use a wire
brush to remove any carbon deposits from the
spark arrester portion of the tailpipe and inside
of the tailpipe housing.
1
1. Gasket
2. Spark arrester
3. Tailpipe
4. Check the gasket for damage, and replace it if
necessary.
5. Make sure the gasket is properly positioned,
then insert the tailpipe into the muffler and
align the bolt holes.
6. Install the bolts and tighten them to the speci-
fied torque.
Tightening torque:
Tailpipe bolt:
8-43
1
2
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
3
8